10 Industrial - Electrical Training Video Course Library

Troubleshoot a contactor that chatters when energized. Course 5: Overcurrent Protection – Fuses & Circuit Breakers Focus: Fuse types, breaker trip curves, selective coordination, and short-circuit ratings.

Using a schematic, find why a pump will not start – all indicators are off. Course 9: Electric Motor Maintenance & Failure Analysis Focus: Megger testing, bearing replacement, alignment, and winding evaluation.

A 50 HP motor trips on overload – megger reading is 2 MΩ at 1000V. Repair or replace? Course 10: Industrial Control Panel Design & NFPA 79 Focus: Panel layout, wire bending space, grounding, and electrical standards. 10 Industrial Electrical Training Video Course Library

| Segment | Topic | Key Demo | |---------|-------|-----------| | 1 | Fuse construction: fast-blow, time-delay, Class CC, J, RK5, T | Cutaway of a Class J fuse | | 2 | Circuit breaker thermal-magnetic trip mechanism | Demonstrate instantaneous vs. long-time trip | | 3 | Understanding trip curves (B, C, D, K) | Overlay trip curves on a single chart | | 4 | Selective coordination – why it matters | Two breakers in series test | | 5 | SCCR (Short-Circuit Current Rating) & fuse replacement safety | Damage from wrong fuse type |

Identify correct PPE for a Category 2 arc flash hazard. Course 2: Multimeter & Electrical Test Equipment Focus: Proper use of DMMs, clamp meters, insulation testers, and voltage testers. Troubleshoot a contactor that chatters when energized

Calculate expected full-load current given HP, voltage, and efficiency. Course 4: Motor Starters & Contactors Focus: Manual and magnetic starters, contactor operation, overload relays.

| Segment | Topic | Key Demo | |---------|-------|-----------| | 1 | One-line diagrams vs. wiring diagrams vs. ladder logic | Trace power from utility to motor | | 2 | Wire numbering & terminal strip labeling | Follow a wire from page 3 to page 10 | | 3 | Finding an open circuit – step-by-step voltage method | Locate a broken wire in a control loop | | 4 | Finding a short circuit – resistance method | Blown fuse investigation | | 5 | Ground fault location using a megohmmeter | Isolate a wet motor winding | Course 9: Electric Motor Maintenance & Failure Analysis

| Segment | Topic | Key Demo | |---------|-------|-----------| | 1 | Megger test procedure – phase-to-phase & phase-to-ground | Acceptable values for 480V motor | | 2 | Surge comparison test for turn-to-turn shorts | Compare good vs. bad waveform | | 3 | Motor bearing types & replacement (grease vs. oil) | Pull a bearing with a puller | | 4 | Shaft alignment – dial indicator vs. laser alignment | Demonstrate soft foot | | 5 | Analyzing failed windings – overload, single-phasing, contamination | Show 5 failed stator photos |