Logixpro Dual Compressor Exercise 2 [Premium • 2026]

She jumped to the control cabinet, fingers flying over the old Allen-Bradley pushbuttons. She disabled the automatic lead-lag and forced Atlas into continuous run. Then she saw the problem: Atlas’s unloader solenoid was sticky. The compressor was starting under full load, drawing 300% amperage. The thermal overload relay clicked once, twice—on the third click, it would trip.

In the LogixPro simulation, you had ladder logic timers: T4:0 for the “minimum run time” and T4:1 for the “anti-cycle delay.” Maria had no time to program. She had to become the PLC. logixpro dual compressor exercise 2

She hit start again.

She smiled, exhausted. “Yeah,” she said. “But in the simulation, the compressors don’t smell like burnt oil and fear.” She jumped to the control cabinet, fingers flying

She sprinted to the MCC (Motor Control Center) and yanked the disconnect for Titan. The massive screw element ground to a halt with a mournful groan. The plant pressure gauge needle wobbled at 92 PSI and began to fall. The compressor was starting under full load, drawing

When the maintenance crew finally replaced Titan’s fan at 4:00 PM, Maria collapsed into a rolling chair. On the HMI, the pressure trend showed a near-perfect line at 88 PSI, with only one brief dip to 81.5 PSI.