Cfesa Refrigeration Practice Test May 2026

If a refrigeration system uses a low-pressure control (LPCO) for pump-down, the control is typically located: a) On the high side, before the receiver b) On the low side, after the evaporator c) At the compressor discharge line d) On the liquid line after the filter-drier

Here’s a for the CFESA Refrigeration Practice Test , designed to mirror the types of questions you’ll encounter on the Certified Food Equipment Service Association exam (refrigeration section). CFESA Refrigeration Practice Test – Sample Questions Section 1: Basic Refrigeration Cycle 1. In a vapor-compression refrigeration system, the component where refrigerant gives up its superheat and latent heat is the: a) Evaporator b) Compressor c) Condenser d) Metering device cfesa refrigeration practice test

A defrost termination thermostat is wired in series with the: a) Evaporator fans b) Compressor contactor coil c) Defrost heater d) Liquid line solenoid Section 3: Troubleshooting & Diagnostics 7. A walk-in cooler has low suction pressure, low superheat, and a starved evaporator. The most likely cause is: a) Overcharge of refrigerant b) Liquid line restriction c) Bad compressor valves d) High evaporator fan speed If a refrigeration system uses a low-pressure control

A system with high discharge pressure and normal suction pressure could indicate: a) Dirty evaporator coil b) Low refrigerant charge c) Non-condensables or dirty condenser d) TXV bulb losing its charge A walk-in cooler has low suction pressure, low